In firmware v5.66 we have fixed the issue with the "Auto Refresh" setting not working in the main page of the Web interface.

  We have added new fields to the MQTT JSON data: 'ts' - timestamp of the time of receipt of the event and 'st' - code for the source of the event. You can also now choose whether incoming MQTT messages should be copied to "/out" or "/mrout".

  There is a new action type "Invert value" in macros - with it you can invert the value of an output or Virtual Output.

   With firmware v5.64, you can implement "access control" functions with NetControl models that have Wiegand inputs (eg NetControl 8R4NT2WG8A), where you can define up to 170 pcs. chip/card codes to run set macros.

   In firmware v5.62, we have corrected the flaw in all time settings (pulse outputs, Sleep in macros) - the real time is practically less with the interval [-1s;0], i.e. if you set a time of 1s the actual will go from just over 0s to 1s. In order to avoid this drawback, we increased the resolution of the timers and now the accuracy of the set time is up to max. 100ms less (ie 1s would be practically 900 to 1000ms).

  The firmware also has a patch in the TCP/IP stack, so we recommend upgrading to this version!

  In the section "Application notes" we have added a new document - "Stuck network equipment restart", in which we consider one of the most frequently solved tasks with NetControl for automatically bringing routers, switches, etc. out of a blocked state.